What does F5 E2 mean on a Whirlpool / Maytag washer?

F5 E2 means: Door lock failure. The most likely parts involved are door lock assembly.

How much does it cost to fix F5 E2?

A typical door / door lock repair costs about $150–$400 nationally, parts and labor included. This is a reference range, not a quote — local prices vary.

Can I still use my washer with an F5 E2 code?

Usually not. The washer will not run a cycle until it can confirm the door is locked. If clothes are stuck inside, unplug the washer and wait a few minutes. The lock may release once power is off.

Why is my washer door locked and won't open after F5 E2?

The lock may be stuck in the locked position. Unplug the washer and wait a few minutes, then try the door again. If water is still in the drum, it may need to drain before the door releases.

Error codes › Washer › Whirlpool

Whirlpool Washer F5 E2 Error Code

Door lock failure

Also shown on Maytag washers.

What's going on

F5 E2 on a Whirlpool or Maytag washer means the machine tried to lock the door or lid but could not confirm it locked. The washer will not start or continue a cycle until the lock works. Start with simple checks like closing the door firmly and clearing anything in the way, then power-cycle the washer.

Before a cycle starts, the washer locks the door or lid so it cannot open while the drum spins or holds water. The control board sends power to the door lock and then waits for a signal that the lock has engaged.

If that signal never comes, or the lock reports a problem, the control stops the cycle and shows F5 E2. This is a safety feature. It keeps the door from opening during a fast spin.

Codes can mean slightly different things on different model generations. Check your model number, usually on a sticker near the door or lid, to confirm what F5 E2 means for your washer.

Likely causes

door lock assembly — The door lock assembly holds the latch and the switch that tells the control the door is locked. If the latch is worn or broken, or the switch or small motor inside fails, the washer cannot confirm a lock and shows F5 E2.

The same code can mean different things on different model generations. Check the model number on your washer's rating plate before ordering parts.

Can you fix it yourself?

Doable for an experienced DIYer with the right part, but many people still call a technician.

Safe things to check first

Open the door or lid and close it firmly. Look for clothing, a sock, or debris caught in the door gap or latch area.
Look at the door strike (the part on the door that goes into the lock) for cracks, bending, or looseness.
Power-cycle the washer: unplug it or switch off its breaker for about one minute, then restore power and try a short cycle.
Make sure the washer is not overloaded and that nothing is pressing against the door from inside the drum.

When to call a technician

If the code keeps coming back after the simple checks, the door lock assembly likely needs to be replaced. A handy owner can do this with the correct part for their model after unplugging the washer, but call a qualified appliance technician if you are not comfortable opening the washer or if a new lock does not fix the code.

What the repair usually costs

$150–$400

Door / door lock repair, parts and labor — national reference range

Confidence: low (based on a single cost guide — treat as a rough guide). Plus a service call fee of about $50–$100, often credited toward the repair.

This is not a quote. Prices vary by region and by model.

Repair or replace?

Repair usually makes sense. Even the high end of this repair stays under $500, about half the price of a typical new washer.

A typical new washer costs about $700–$1,300.

Check your washer — free, 2 minutes

Common questions

What does F5 E2 mean on a Whirlpool / Maytag washer?: F5 E2 means: Door lock failure. The most likely parts involved are door lock assembly.
How much does it cost to fix F5 E2?: A typical door / door lock repair costs about $150–$400 nationally, parts and labor included. This is a reference range, not a quote — local prices vary.
Should I repair or replace my washer?: Repair usually makes sense. Even the high end of this repair stays under $500, about half the price of a typical new washer.
Can I fix F5 E2 myself?: Doable for an experienced DIYer with the right part, but many people still call a technician.
Can I still use my washer with an F5 E2 code?: Usually not. The washer will not run a cycle until it can confirm the door is locked. If clothes are stuck inside, unplug the washer and wait a few minutes. The lock may release once power is off.
Why is my washer door locked and won't open after F5 E2?: The lock may be stuck in the locked position. Unplug the washer and wait a few minutes, then try the door again. If water is still in the drum, it may need to drain before the door releases.